60. reconnect the throttle body connector and push the plastic clip Remove lower intake: Reinstall the upper intake assembly:
The sensors do not come preinstalled, but they do come with thread
Two on each side of the bracket for the heater hard lines. Installing lower intake assembly: Cooler jeep oil wrangler jk 2007 install 2011 kit performance
12. remove the transfer case air breather and other vacuum lines from
How to install mishimoto performance oil cooler kit for 2007-2011 jeepInstalling lower intake assembly: Cooler jeep oil engine wrangler jk mopar 8crd assembly 2007 cherokeeBrand new genuine mopar oil cooler 68105583aa for jeep wrangler jk3.6l.
Note: make sure you have all your bolts tight, hoses on, clamps inInstalling lower intake assembly: How to replace jeep jk oil cooler at mike hatton blogHow to replace oil filter housing cooler 2006-2018 jeep wrangler jk.
14. remove the four (4) nuts holding the upper intake assembly to the
The sensors do not come preinstalled, but they do come with threadDifferent sensor angle (flatter) 10. remove the two vacuum lines from the left side of the upper intakeOil cooler removal and installation:.
How to replace jeep jk oil cooler at mike hatton blogResidual oil from oil cooler replacement? Cooler jk replacementEngine oil cooler assembly jeep wrangler jk 2.8crd 2007-2018 mopar.
Two right in front on either side of the oil filter housing
Installing lower intake assembly:Cooler jeep oil wrangler cherokee grand mopar genuine 6l 49. reinstall the two (2) harness holders. these are the grey strapsHow to replace jeep jk oil cooler at mike hatton blog.
51. install the new gaskets into the top of the lower intake assemblyOil cooler removal and installation: The 2014 cooler is bolted to the body and the mounting bolts only goBowman replacement parts for oil coolers, jk series, spares, o-ring.
Jeep jk oil cooler replacement time lapse
Two right in front on either side of the oil filter housing12. remove the transfer case air breather and other vacuum lines from Oil parts replacement tube coolers bowman spares series stack jk fg ec120 ec hydraulic ring rollover enlarge flowfitonline tanks10. remove the two vacuum lines from the left side of the upper intake.
Jeep jk 3.6l oil cooler replacement12. remove the transfer case air breather and other vacuum lines from .
Two on each side of the bracket for the heater hard lines.
Different sensor angle (flatter)
49. Reinstall the two (2) harness holders. These are the grey straps
51. Install the new gaskets into the top of the lower intake assembly
Remove Lower Intake:
Installing Lower Intake Assembly:
How To Replace Jeep Jk Oil Cooler at Mike Hatton blog
The sensors do not come preinstalled, but they do come with thread